LV19 Livingston
A lot of boat packed into nineteen feet
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
- LOA: 221″(18′-5”)
- Molded LOA: 221″(18′-5”)
- Beam: 90″(7′-6”)
- Draft: 9″ (w/ 90HP)
- Freeboard: 16”
- Shaft Length: 20”
- Apprx. Dry Weight: 1,600 lbs (hull only)
- Max HP Rating: 115 HP
- Fuel Capacity: 20 gal
- Boat Capacity: 1,800 lbs (7 persons, motor and gear)
- Typical Cruise*: 23 mph at 6.1 mpg
- Typical WOT*: 39 mph at 4.1 mpg
* Tested with 90HP motor, two people, 1/2 fuel, no gear
- 100% composite construction (completely wood-free)
- Unique twin hull design with tunnel lift appeals to shallow water enthusiast as well as those who like to fish in deeper waters
- Buoyancy in twin-hull design allows more load bearing capacity, shallow draft, quicker planning, and a smoother ride
- Twin-hull design provides more interior space than competitively sized mono-hulls
- Twin hull design performs with smaller, lighter, and less expensive motors for better fuel efficiency
- Constructed with high-gloss MAXGUARD exterior gelcoat, 24-oz hand laid woven roving, and durable flat interior finish with contrast webbing
- Reinforced outboard transom, fabricated with 1” thick Penske composite board encased in fiberglass, will not rot
- Laminated sub-floor with foam-filled cavity encased in fiberglass (will not absorb water if there is a hull breach)
- Laminated-in fore and aft seating (not bolted-on) with (2) rear access hatches and (3) forward hatches
- Curved SPRAY GUARD gunwale & protective gunwale edge trim
- Fiberglass center console helm station with stainless steel steering wheel, acrylic windscreen, stainless steel grab rail, forward storage / seat, 20-gallon fuel tank, and horn
- Helm bench /cooler seat with flip-forward seatback cushion (can be plumbed for a livewell)
- Rigging tubes under floor running console aft
- Transom bilge pump in each sponson (2 x 500 gph)
- 6 switch panel: navigation lights, port bilge pump, starboard bilge pump, and (3) accessories switches
- Navigation lights on each side of the console, the stern light aft on a 48” pole.
- (2) motor well thru-hull drains and (3) transom garboard drains
- (4) mooring cleats plus (1) stainless bow eye and (2) stern eyes
Accessories
- Stainless steel bow rail
- Stainless steel forward grab rail
- Stainless steel side rail
- Keel strips on each sponson
- Livewell
Motors
- Yamaha 90 HP 4-stroke with control, tach, and prop (remote motor F90LA)
- Yamaha 115 HP 4-stroke with control, tach, and prop (remote motor F115LA)







